Auro Wall Filler 329
Auro Wall Filler 329
Wall filler in powder form to be mixed with water
Product Overview
Main purpose
Wall filler in powder form to be mixed with water. For repairing cracks, holes and unevenness before painting or wallpapering.
Use it on
Fully dried, untreated plastered surfaces (lime plaster, lime-cement plaster), bricks, concrete or other absorbent, purely mineral surfaces
Overview
Wall filler in powder form ready to be mixed with water. For repairing cracks, holes and unevenness on plaster, stone and brick before painting or wallpapering. Not suitable for outdoor use, on floors or in rooms with constant high moisture.
Features
- Breathable
- Virtually VOC Free
- Transparency of Ingredients
- Vegan Friendly Product
- Easy to Apply
Benefits
- Allows the Surface to Breathe
- Solvent Free
- Ingredients are listed on the bag and in the data sheet
- Easy to mix
Questions
There are currently no questions and answers published for this product
Technical Details
Key Technical Data
Installation Guide
Make sure surface is clean and stable and moisten slightly before application.
Mix Auro wall filler into water. You should obtain a paste-like substance, free from lumps.
Mixing proportions:
2 parts (weight) of wall filler and 1 part of water, or
3 parts (volume) of wall filler and 1 part of water
After 2 minutes, mix again and if necessary add more water.
Apply using a filling knife, trowel or putty knife.
Once dry, sand finely if necessary using sand paper.
When filling joints of wall ceramic tiles the joints must be moistened first. Afterwards apply the filler in two steps (first crossways and then diagonal to the joint).
Spread out over the surface with a rubber knife. - As soon as a white film appears on the joints, clean with a wet sponge and polish with a cloth.
To insure proper hardening, moisten the joints slightly after about 5 hours with a sponge.
Final hardness will be achieved after 36 hours.

